Fits a unique need in a unique spot.

David K Verified Purchase

Dimple & Die Set -100 Degree 3/32

Makes perfect dimples. Easy to use

Jim W Verified Purchase

Dimple & Die Set -100 Degree 3/32

works as specified.

Jim M Verified Purchase

Dimple & Die Set -100 Degree 3/32

amazing tool! inexpensive and sturdy.

Rick S Verified Purchase

Dimple & Die Set # 5102D-1/8

These work fine, just be careful not to pull too hard. The nail stretches each time you use it until it breaks, but the dimples are accurate.

Reginald C Verified Purchase

Dimple & Die Set -100 Degree 3/32

Works Great at a reasonable cost.

David M Verified Purchase

Dimple & Die Set # 5102D-1/8

Haven’t needed this yet

Tom Q Verified Purchase

Dimple & Die Set # 5102D-1/8

This dimple set works great for the holes the squeezer can’t reach.

Dimples in a .038 aluminum sheet were excellent. It likely can do harder or thicker materials too. Comes with only five standard stainless steel nails with diameter fitting the rivet holes. I broke the first nail after 15 dimples. Beware: when the nail breaks, the die shoots off, and the tiny thing is hard to find in a crammed workshop.

Johannes H Verified Purchase

Dimple & Die Set # 5102D-1/8

This product works as advertised but is not terribly durable. The dimple degrades over a short time. Additionally, the center shaft (nail) fails after a half dozen dimples. It’s good that a spare is provided. This will allow for maybe a dozen dimples. Then you must find a replacement “nail” to continue. For the price, though, it does work.

Does it dimple? Yes. Picture is deceiving. The shaft that you pull with a squeezer is not anything special. It is simply a nail. Thats it. A hardware store nail you would drive into a piece of wood. Its also a little smaller than 1/8 which doesnt help the die center on the dimple. Also the nail heads arent straight so the die gets squeezed at an angle.