|Valves||Mfg. No.||Engine Application||Thread||Part Number||Price||Buy|
|P7500||Franklin Engines||3/4" NPT|
|P5000||Lyc. (same as Aeroquip AE80664H)||1/2 NPT|
|M20150||Subaru 2.2L / 2.5L||20-1.50mm|
|S6250||Cont. (same as Aeroquip AE99950G))||5/8-18|
|S5020J||Jabiru 2200 / 3300||1/2"-20|
|M12175||Rotax 912 / 914*||12mm x 1.75|
|RM12175||Rotax 912 / 914 Adapter - for M12175|
*Must be used with late model Rotax oil sumps
|12mm x 1.75|
|S1000||Cont. (same as Aeroquip AE80666H)||1-18|
LOCK OPEN OIL DRAIN VALVES
Changing hot engine oil has never been easier! With the SAF-AIR oil drain valve, no wrench is needed to remove the drain plug. A simple push and turn of the SAF-AIR valve locks it in the open position. The valve is made completely from anodized aluminum and stainless steel components. These materials are used throughout the aircraft industry due to their strength and durability. FAA & PMA APPROVED.
Very high quality valve complete with thread lube and gasket. Perfect fit as advertised.
The right part!
Fit perfectly! I have one on my 152, and now on my 177RG. Used with the Power-Flow exhaust, and it is great.
so far so good. installed and working well. this replaced an old drain i had. I like the barbed nipple which should hold the hose quite well.
I got the F6250, very well made, very happy with it.
S5020J--using in a marine oil pan.Excellent quality.Perfect for what I need.
Excellent part, easy to install, decreased the time required to change my oil! Why did I wait? I have no idea. Id highly recommend this product.
I have installed several of these quick drains and never had a problem. Great quality valves easy to install and remove. Thanks, MattJ
Per the Application Chart in the "Overview" tab of this web page, the recommened oil drain valve for the TSIO-360FB engine is S6250 (our part number 06-00637). We recommend you always check your currenlty installed valve to verify correct replacement.
2 each of AN6227B-6 and 1 each of AN6227B-7 are the replacement o-rings for the valve.
Drain valve S6250 requires qty 2 AN6227B-6 and qty 1 AN6227B-7 o-rings, and qty 1 AN900-10 copper crush gasket for installation.
The P5000 has o-rings installed at the factory, and has 1/2"NPT threads to install in the sump. No other o-rings are required for a new installation.
If the engine was produced after mid 2015 it will have the late model tank.
Approx 2.625 inches total length.
You will not need a separate fitting as the valve already has a nipple hose connection attached to it.
It does come with the crush gasket and the replacement would be an AN900-7.
This measures 2" from top of the nut to the end of the nipple. The widest part of this unit is 15/16".
This would take qty: 1 of P/N# 04-03836.