|HAND RIVET SQUEEZER THS-10||1-1/4" Gap x 1" Reach|
|HAND RIVET SQUEEZER THS-15||1-1/4" Gap x 1-1/2" Reach and 3/16 set hole|
|HAND RIVET SQUEEZER THS-20||1-1/4" Gap x 2" Reach|
|HAND RIVET SQUEEZER THS-22||2" Gap x 2" Reach|
|HAND RIVET SQUEEZER THS-25||1-1/4" Gap x 2-1/2" Reach|
|HAND RIVET SQUEEZER THS-30||1-1/4" Gap x 3" Reach|
|HAND RIVET SQUEEZER THS-35||1-1/4" Gap x 3-1/2" Reach|
|HAND RIVET SQUEEZER THS-40||1-1/4" Gap x 4" Reach|
|HAND RIVET SQUEEZER THS-50||1-1/4" Gap x 5" Reach|
|HAND RIVET SQUEEZER THS-60||1-1/4" Gap x 6" Reach|
|HAND RIVET SQUEEZER THS-100||1" Gap x 2" Reach|
|HAND RIVET SQUEEZER THS-101||1-1/4" Gap x 1" Reach NO set hole on top|
|This tool was designed and built as a portable low cost solution for both small and large aerospace applications. It is made of aerospace grade stainless steel and heat treated on all wear and deflecting components to 38/42 on the Rockwell Hardness Scale. A large variety of interchangeable yokes are available with ranges from as small as 1.00" to 6.00" reach. It has proven itself over the years as a portable rugged solution, for light to medium duty, rivet squeezing applications.|
I got the 3 reach (THS-30) and while it works great, gets everywhere I need it to, sometimes the jaws need a gentle nudge to retract back open. I suspect its just a very low-tolerance tool and will loosen up a little with time, but that was a minor annoyance for me. Also worth mentioning, it does not come with any yokes (hard points for the jaws) so you will need to buy those separately. Not a complaint at all, just something to note.
No manual, just a yoke replacement procedure. If you butterfly the handles you can adjust rivet set holder up or down. You can also squeeze handles and rotate set holder with 1/8" rod using side hole on set holder.