Aircraft Spruce Canada
Brantford, ON Canada
Corona, CA | Peachtree City, GA
Chicago, IL | Wasilla, AK
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
- JUMP TO
- Overview
- Reviews
- Q&A
- View in Catalog
Overview
|
For dimpling in hard to reach places. Works with any hand pop rivet tool. Can be used over & over. Works for both 100 & 120 pop rivets. Extra nails included (Uses standard hardware store nails). 2 sizes available. Note: The pop rivet dimplers show above are made with 100° angles, same as regular dimple dies. They will work with either solid flush rivets (AN-426 – 100°) or with pull type rivets such as a AVEX rivets (120°), etc. The dimple formed with these pop rivet dies will not be as ‘sharp’ as dimples formed with regular dimple dies. This is because you get more pressure with a squeezer or a hammer than with a pop rivet puller; however, the dimples formed with pop rivet dimplers are adequate for occasional use in tight or hard-to-use places. |
Reviews
Creates a respectable dimple in hard to reach places
Verified Purchase
AVERY POP RIVET DIMPLER 3/32"
I used it to make a few dimples in the stainless steel firewall. Worked great.
Verified Purchase
AVERY POP RIVET DIMPLER 3/32"
Verified Purchase
AVERY POP RIVET DIMPLER 3/32"
Does a good job
Verified Purchase
AVERY POP RIVET DIMPLER 1/8"
Nice. Easy to use, Enlarges the hole slightly, especially in .016 sheet.
Verified Purchase
AVERY POP RIVET DIMPLER 3/32"
must have tool that worked well
Verified Purchase
AVERY POP RIVET DIMPLER 3/32"
must have tool that worked well
Verified Purchase
AVERY POP RIVET DIMPLER 1/8"
I used both sizes, 3/32 and 1/8. Both worked well. No issues.
Verified Purchase
AVERY POP RIVET DIMPLER 1/8"
This is the only product that will dimple several of the holes in our assemblies. They work great!
Fine product Jim, and sons.
Q&A
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The dimensions of this nail is 1.97" length and .091" OD.
It will work with any hand pop rivet tool.
