Other Customers
Have Also Viewed:
Have Also Viewed:
FLAP HANDLE
|
This flap handle is a well built, durable, and cost effective alternative to the plain round standard flap toggle switch that exists in most experimental aircraft. This unit is easily installed over the existing toggle switch with the included set screws. This unit is powder coated for a long lasting, durable finish.
Note: This is the Flap Handle Only |

![]() ![]() ![]() ![]() ![]()
|
INSTALLATION Installation is quick and straightforward. To ensure proper alignment and operation: 1) Before installation... Make sure the toggle switch is tight on the panel, and that the toggle motion is straight up and down. 2) When installing... Start with both set screws flush with the surrounding handle surface. Alternate from side to side, tightening each screw the same number of turns until both are tight. OPERATION These flap handles are a significant improvement over a toggle switch alone or standard vinyl covers. Much more comfortable. Make fine adjustments easier. |
![]() ![]() ![]() ![]() ![]()
|
Works and looks as advertised. Could have given 5 stars if it wasnt for the price. Rather expensive for a piece of plastic with 2 set screws. Anyway, it looks good. |
![]() ![]() ![]() ![]() ![]()
|
Beautifully machined piece. The previous review is not correct. The piece is machined out of aluminum and then powdercoated. It is most definitely not plastic!!! |
![]() ![]() ![]() ![]() ![]()
|
Nice piece of work. Makes a big difference on the flap switch of an LSA. You just have to find a small wrench to fit the set screws! 5 stars if the mini wrench was included! |
![]() ![]() ![]() ![]() ![]()
|
This is a very nice handle though it does not work with toggle switches with a toggle that spins. You would need the anti-rotation plate as well. I bought the handle alone and found our the switch I intended to use rotated. So I called AS and they were able to get me the anti-rotation plate by itself. This handle will work with switches where the toggle is pinned like the more expensive Honeywell switches - that is if you dohnt want the plate. |
![]() ![]() ![]() ![]() ![]()
|
I like it. The flap handle was simple to install over the existing switch and makes flap operation a no look procedure on touch and go landings and go arounds. |
![]() ![]() ![]() ![]() ![]()
|
I thought I was ordering a flap handle that actually works not just a handle and a plate. I need the actual mechanism that this will actually work with |

What are the dimensions /diameter of the mounting hole for the flap handle?
The flap handle mounting hole diameter is about .245 in diameter to fit a standard size toggle.
What is the width of the flap handle? I want to surround it with aluminium channel. Thanks
3/4 inch width.
Part Number | Description | Price | ||
![]() |
11-11338 | FLAP HANDLE & ANTI-ROTATION COMBO | N/A | Click here for details |
Newsletters