Comant’s two internal hole stud mount blade style transponder antenna with BNC port. Designed as a non-TSO antenna specifically for home built and LSA aircraft. Frequency range supports ADS-B Out and DME applications. Suitable for either top or bottom mounting with light fixed wing single engine / multi-engine and helicopter aircraft. |
MODEL CI E05 ADS-B Out / Transponder / DME | |
Electrical | |
Frequency | 960 - 1220 MHz |
VSWR | 1.5:1 Max 960 - 1220 MHz 1.3:1 Max 1025-1150 MHz |
Polarization | Vertical |
Radiation Pattern | Equivalent to 1/4 wave stub |
Impedance RF | 50 Ohms |
Resistance DC | Open Circuit |
Power RF | 2.5 KW Peak |
Mechanical | |
Weight | 0.3 lb. |
Height | 3.26 in. |
Finish | Polyurethane Enamel |
Connector | BNC (Female) |
Gasket | B10505 |
Direct replacement for the certified model I had on my RV7 at a much better price. Works perfectly, would absolutely buy again
Easy install, comes with gasket, big cost savings over TSO for our experimental aircraft. Like it!
COMANT TRANSPONDER BLADE ANTENNA CI-E05
This antenna meets the requirements for garmin ADSB equipment. It is good quality and works well.
COMANT TRANSPONDER BLADE ANTENNA CI-E05
great value for experimental
COMANT TRANSPONDER BLADE ANTENNA CI-E05
Great price, easy install, functions great !
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
No, unfortunately we do not carry this gasket.
Studs are approx 3/8 length.
The E Series product line (CI E01, CI E05, CI E21 and CI E22) have the same quality and performance as its certified Comant counterpart. The E Series product line comes without TSO certification and has a one year warranty compared to the three year warranty on certified Comant products and thus has a price point suited for the experimental and LSA market.
The manufacturer no longer supplies these with the gasket and requires the sealant to be used instead.
This is a transponder antenna and will support ADS-B in and out if the transponder is equipped for both. For ADS-B, you also need a WAAS GPS antenna.
Yes, this will work with that transponder in an experimental application.
Yes, the GDL39R is compatible with the CI E05 antenna.