Airtac 3 is a spray adhesive designed for temporary bonding. It can be used to hold dry materials on contours and vertical surfaces. This product is ideally suited to resin infusion applications for holding plies, release films, peel plies, and infusion mesh in place until the vacuum bag is secured. Airtac 3 has a fine pebble spray pattern which reduces airborne material. This reduces overspray and user exposure.
Product can be applied to one or to both bonding surfaces. Ensure surfaces are clean and free of FOD, grease, oil, wax, etc. For the best results surfaces should be between 50-86°F (10-30°C).
Use with adequate ventilation. Shake aerosol well before use.
Spray 6-10 inches (15-25 cm) away from the surface at 90° to the surface, applying an event coat. Allow the adhesive to tack off until there is no transfer when touched.
Join surface and press firmly together.
Consult SDS prior to use. Do not store at temperatures over 122°F (50°C). Avoid exposure to sunlight. Do not store directly on concrete floor.
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.