Other Customers
Have Also Viewed:
Have Also Viewed:
THERMO-TEC COOL IT MAT
![]() |
![]() |
Use the Cool-It Mat to battle excessive heat and noise that penetrate the driver compartment through the firewalls and floorboards. It is also perfect in doors, under hoods, and above transmission housings. The Cool-It Mat is composed of resin-bonded silica blanketing insulation sandwiched between a Mylar facing on one side and a foil facing on the other. The highly-reflective Mylar reflects heat up to 2000 degrees Fahrenheit away from surfaces, while the foil side is orientated away from the heat source to conduct any penetrating heat across its surface thus providing the ultimate in heat protection. The silica blanketing is a dual-density composite and is the main sound insulator. It is easy to trim and can be applied with the push-in fasteners provided or any weather strip adhesive. Available in three convenient sizes, including a 50' roll, Cool-It Mat is about 1/2" thick. |
- 24" x 48" x 1/8" thick
- Temperature range of insulation: 400 degrees F
- Temperature range of foil: 1200-1500 degrees F
- Weight: 14.5oz Square yard
- Weight per square foot is .34 of a pound
- Thermal conductivity rating of .270 Btu/hr.ft.degF @ 75 degrees F
- Thermal resistance rating R of .92 (m2K)/W
- Noise reduction: 3-5 db
- Bulk density is 1.84 pounds
- Flammability: MD 4.0 in/min max and CMD 4.0 in/min max

What are the dimensions of the mat?
24" x 48" x 1/8" thick.
What is the temperature range of this Cool It Mat?
Per the supplier: Temperature range of insulation is 400 degrees F and Temperature range of foil is 1200-1500 degrees F.
Is this insulation FAA approved for certified aircraft? Looking to install in a Beech Sundowner. How much does it weigh?
This is not FAA approved. It is intended for experimental aircraft use. A 24" x 48" piece will weight about 2lbs.
Is the Thermo Tec Cool-it mat self adhesive?
No. The Cool-It does not have self-adhesive.
Which side of the Thermo-Tec Cool It mat goes toward the firewall, the quilted side or the other?
The foil side is for heat deflection from the heat source, so the other side would be against the firewall, and foil side to the engine.
Newsletters